Troubleshooting – Icom iM304 User Manual
Page 41
35
9
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
No sound from speaker. • Squelch level is too high.
• Volume level is too low.
• Speaker has been exposed to water.
p. 7
p. 7
p. 9
• Set squelch to the threshold point.
• Set [VOL] to a suitable level.
• Drain water from the speaker.
The transceiver does
not turn ON.
• Bad connection to the power supply.
p. 31
• Check the connection to the transceiver.
Transmitting is impossi-
ble, or high power can
not be selected.
• Some channels are for low power or re-
ceive only.
• The output power is set to low.
pgs. 5,
6, 36
p. 7
• Change channels.
• Push [HI/LO] on the microphone to select
high power.
Scan does not start.
• “TAG” channel is not programmed.
• Set the desired channels as “TAG” channels. p. 11
No beeps.
• Beep tones are turned OFF.
• Turn the beep tone ON in Set mode.
p. 30
Distress call cannot be
transmitted.
• MMSI (DSC self ID) code is not pro-
grammed.
• Program the MMSI (DSC self ID) code.
p. 13
8
9