Ives Offset Top Pivot 7215/15F User Manual
Page 2
26672 Rev. 4
It is very important for installer to verify that center line of top pivot point lines up
with center line of bottom pivot point before final installation. Heel edge of door
must be beveled 1/8” in 2” as shown below. The bottom pivot set should be
mounted first in most installations.
NOTE
!
Mortise depth for pivot leafs is 1/4”.
NOTE
!
These dimensions apply to industry standard
1-3/4” door in a 1-15/16” rabbeted frame. For
other frame conditions, locate frame leaf of
pivot identical to door leaf as shown below.
*
3/4”
19 mm
15/16”
24 mm
1/8”
3 mm
typ
1/16”
2 mm
typ
Frame Leaf
*
*
7/8”
22 mm
11/16”
17 mm
Door Leaf
Bevel heel edge of
door 1/8” in 2” with
3/16” rad, typ
26672-00
This manual is related to the following products: