Ives VR900 - Manual

829562_00(3) Copyright © 2003 Ingersoll-Rand. All rights reserved.
PREPARE DOOR FOR MORTISE LOCK. SEE MORTISE
LOCK INSTRUCTIONS FOR PREPARATION.
ALIGN TRIM TEMPLATE WITH HORIZONTAL
CYLINDER CENTER LINE ( C ) ON PULL SIDE EDGE
OF DOOR AND SECURE WITH TAPE.
MARK THE CENTER POINT OF EACH HOLE
WITH A PUNCH.
USING A SQUARE, TRANSFER THE 4
MOUNTING HOLE LOCATIONS TO THE
OPPOSITE SIDE OF THE DOOR.
HOLE DIMESIONS AND PREPARATION
ARE SHOWN ON TEMPLATE.
LOCATE AND PREPARE ALL TRIM HOLES
AS SHOWN ON TEMPLATE.
SECURE TRIM TO PULL SIDE OF DOOR.
SEE MORTISE LOCK INSTRUCTIONS FOR
MORTISE LOCK AND CYLINDER INSTALLATION.
WHEN USING A BEVELED
DOOR, MAKE SURE TO
MEASURE HOLES FROM
THE FURTHEST EDGE AS
SHOWN
TRIM
SIDE
1
2
3
4
5
6
7
RHR SHOWN
LHR OPPOSITE
VR900/VR904 TRIM
1/4” COUNTERSINK
WASHERS (4)
SCREWS (4):
1/4-20 X 1-3/8”
OPHMS SCREWS
(1-3/4” DOORS)
1/4-20 X 1-3/4”
OPHMS SCREWS
(2-1/4” DOORS)
USE WAVE WASHERS
INSIDE CYLINDER
COLLAR AS NEEDED
FOR PROPER FIT
CYLINDER COLLAR
VR900 TRIM
TEMPLATE
RHR SHOWN
LHR OPPOSITE
OF
CYLINDER
L C
L
INSTALLATION INSTRUCTIONS
FOR USE WITH MORTISE LOCKS (ON PULL SIDE OF DOOR)
VR900/VR904 VANDAL RESISTANT TRIM