IBM 4 LINE TELEPHONE WITH CALLER ID -412CID User Manual

Page 22

USING AUTO REDIAL

If the phone number dialed is busy or not answered, the phone can automatically redial the number
approximately every 60 seconds up to 10 times.

1. Press an available [LINE] key [LINE1, LINE2, LINE3, or LINE4]
2. Press [REDIAL]. The [REDIAL] LED will flash and the [MUTE] key will be lit, indicating the phone

is in Auto Redial mode. No further action is needed.

To cancel Auto Redial:

1. Press [REDIAL] and hang up the phone.

ANSWERING AN INCOMING CALL

Using the Handset

1. Lift the handset. You will automatically be connected to the ringing outside line.

Using the Speakerphone (hands free)

1. Press the [LINE] key with the flashing LED to be connected with the outside call or simply press

the speakerphone [SPKR] key to be automatically connected to the ringing outside line.

2. Press the [SPKR] key again to end the call.

PLACING A CALL ON HOLD

Placing a Call on Hold

1. Press the [HOLD] key to put the current line on hold. The line LED will flash rapidly.

Releasing a Call on Hold

1. To release a call on hold, press the [LINE] key of the call that is on hold.

NOTE: You can access the line (call) on hold from any extension.