Ives 232TGSL User Manual
Page 16

16
Maintenance Section (Continued)
1. Coat Hammers (33) with a light film of
Ingersoll--Rand No. 100 Grease.
2. Replace Hammers in Hammer Frame (30) exactly as
they were when you marked them prior
If you are installing new Hammers or want to
change the location of the existing Hammers
to utilize both impacting surfaces, slide the
Hammers in the Hammer Frame so that the
half--round notch on one Hammer is located on one
side of the Frame and the half--round notch on the
other Hammer is located on the other side of the
Frame.
3. Replace Hammer Pins (31).
4. Examine base of Anvil (40) and note its contour.
While looking down through the
Assembly of the Impact Wrench
1. Set assembled impact mechanism down over splined
hub of Rotor.
2. Smear a thin film of Ingersoll--Rand No. 100 Grease
on inside surface of Hammer Case
3. Install Hammer Case Cap Screws (38). Tighten
Hammer Case Cap Screws to 60 to 70 in--lb.