Inter-Tel 831.10507 - Manual (Page 7)

7
CHOOSING A LOCATION FOR THE HYDROTHERAPY SPA
There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary
depending on whether you use the hydrotherapy spa inside or outside. We have listed several factors you may
wish to consider as you decide where you want to use the hydrotherapy spa.
If you set up the hydrotherapy spa inside:
1. The hydrotherapy spa will increase the level of
humidity in your home. The location you choose
should be well ventilated. You may need to install
a ventilation fan or use a dehumidifier.
2. The hydrotherapy spa should be close to a source
of water.
3. Do not use the hydrotherapy spa on carpet or
other material that may be damaged by moisture.
We recommend that you place the hydrotherapy
spa on a water- and stain-resistant, non-slip sur-
face with a floor drain for any water that may
splash from the hydrotherapy spa.
4. Be sure that the location you choose is stable. It
must be able to support the weight of the
hydrotherapy spa when it is filled with water, plus
the weight of the occupants. The hydrotherapy
spa weighs approximately 2,000 pounds (908 kgs)
when filled with water.
5. Do not use the hydrotherapy spa above a finished
living area, due to the risk of water damage.
6. Make sure that there is enough room around the
hydrotherapy spa to permit servicing. The dimen-
sions of the spa are: 5’ 10” W x 6’ 4” L x 2’ 6” H
(153 cm x 183 cm x 61 cm). Allow for this size
when choosing the location.
7. The hydrotherapy spa is not designed for in-floor
installation. However, it is compatible with a deck
system that is built flush with the top of the spa,
provided you leave access to the motor for servic-
ing.
8. Make sure to note any other considerations, such
as aesthetics or privacy concerns, that may affect
the safety or enjoyment of using the hydrotherapy
spa.
If you set up the hydrotherapy spa outside:
1. Check your local building codes concerning the
use of outdoor spas.
2. The hydrotherapy spa should be close to a source
of water.
3. We recommend that you place the hydrotherapy
spa on a water- and stain-resistant, non-slip sur-
face. Do not use the hydrotherapy spa on rough
or sharp surfaces such as gravel or wood chips.
4. Make sure that the location you choose is stable.
It must be able to support the weight of the
hydrotherapy spa when it is filled with water, plus
the weight of the occupants. The hydrotherapy
spa weighs approximately 2,000 pounds (908 kgs)
when filled with water.
5. Consider environmental factors such as rain, wind,
shade, sunlight, etc.
6. You should be able to monitor the use of the
hydrotherapy spa from your home to prevent
unauthorized use by children. You may want to
enclose the spa with a fence and self-latching
gate to prevent unauthorized use.
7. Make sure that there is enough room around the
hydrotherapy spa to permit servicing. The dimen-
sions of the spa are: 5’ 10” W x 6’ 4” L x 2’ 6” H
(153 cm x 183 cm x 61 cm). Allow for this size
when choosing the location.
8. The hydrotherapy spa is not designed for in-
ground installation. However, it is compatible with
a deck system that is built flush with the top of the
spa, provided you leave access to the motor for
servicing.
9. Make sure to note any other considerations, such
as aesthetics or privacy, that may affect the safety
or enjoyment of using the hydrotherapy spa.