Inter-Tel 831.10507 - Manual (Page 12)

12
A
A
B
B
D
E
A
A
C
A
D
A
B
B
SPA SHELL DIAGRAM
SPA OPERATION
Refer to the diagram above. The function of each
component is explained below.
The eight fixed thera-jets (A) are located on the
sides of the spa. Five jets focus a water massage on
your upper or lower back and three jets provide a foot
water massage for three of the seating positions.
The six multi-directional thera-jets (B) can be
adjusted for a custom water massage. Two of the jets
are located on the reclining seat and focus a water
massage on your lower back. The other four jets,
located on the bench seats, focus a water massage
on your lower or middle back. Note: To shut off a
multi-directional jet, simply press the jet in; to turn a
jet back on, pull the center slightly.
This spa is ozone ready. An optional ozone generator
can be installed to utilize the ozone jet (C). Ozone
provides a way to help sanitize your spa with minimal
chemical treatment.
The suction vents (D) near the floor of the spa bring
water into the pump in order to operate the system.
The suction covers should always be in place over
the suction vents. Never operate the spa without
the suction covers in place.
The filter (E) can be removed for cleaning and
replacement (see CHECKING AND CLEANING THE
FILTER on page 18).
The temperature probe (F) reads the current water
temperature, which is displayed on the console.
The spa also has a light (G) for your safety and con-
venience during evening use.
Use of the console (H) is explained on pages 13 and
14 of this manual.
Note: The spa offers automatic freeze protection. If
the water temperature falls below 40°F (14°C), the
pump will begin circulating and heating the water to
prevent the water from freezing.
F
G
H