2 removing/installing the batteries, Removing, Caution – Invacare Lynx L-3X User Manual
Page 41: B. lift the battery from the battery tray, Repeat step 6 to remove the remaining battery, Installing
10 BATTERIES
41
10.2 Removing/Installing the Batteries
Removing
1.
Place the powered scooter in a well ventilated area.
2.
Turn power off and remove the key from the ignition.
3.
Remove the seat. Refer to Removing/Installing the Seat on page 27.
4.
Lifting up to release the hook and loop strips, remove the rear shroud from the scooter.
5.
Disconnect the two GRAY battery connectors from the wiring harness connectors.
6.
Perform the following to remove a battery from the battery tray:
A. Pull the hook and loop fastening battery strap apart.
B.
Lift the battery from the battery tray.
7.
Repeat STEP 6 to remove the remaining battery.
8.
If necessary, remove the battery cables. Refer to Connecting/Disconnecting the Battery Cables on page 43.
Installing
1.
Place the powered scooter in a well ventilated area where work can be performed without risking damage to carpeting or floor covering.
2.
Turn power off and remove the key from the ignition.
3.
If necessary, connect the battery cable. Refer to Connecting/Disconnecting the Battery Cables on page 43.
4.
Remove the seat. Refer to Removing/Installing the Seat on page 27.
5.
Lifting up to release the hook and loop strips, remove the rear shroud from the scooter.
For this procedure, refer to FIGURE 10.3 on page 45.
ƽ
CAUTION
Work should be performed in an area without risking damage to carpeting or floor covering.