iSymphony CR8CD - Manual (Page 8)

L ISTENING TO THE RADIO
M anual Tuning
1. In Tuner mode,Press “ /BAND” button to select the desired BAND (AM or FM).
2. Tune to the desired station by pressing the or button.
3. Adjust volume control to the desired volume level.
A uto Tuning
1. In Tuner mode, press “ /BAND” button to select the desired BAND (AM or FM).
2. Press and hold the or button for 1-2 seconds and then release.
3. The unit will start seeking automatically and stop when the radio station is reached.
4. Repeat steps 2 and 3 until the desired radio station is reached.
5. Adjust the volume control to the desired volume level.
P reset Stations using Remote Handset
You can store up to a total of 20 radio stations in memory.
1. Set to TUNER mode.
2. Turn to the desired radio station by “MANUAL” or “AUTO” tuning method.
3. Press “
PROG/ADJ” button to enter programming mode.
4. Press PRE - or PRE + button to select the desired station memory for storage.
5. Press “
PROG/ADJ” button again to confirm the setting.
6. Repeat steps 2 to 5 to store other stations.
7. Press PRE - or PRE + button to reload the preset stations in order.
8. The unit will return to normal TUNER mode if no buttons are pressed.
FM and FM Stereo Reception
Press the ST./MONO button on the remote handset to select “MONO” or
“STEREO” reception mode.
H ints for Best Reception
- AM: the receiver has a built-in AM bar antenna. If AM reception is weak, slightly
rotate or reposition the unit to improve the AM reception.
- FM: the receiver has an attached FM wire antenna at the back of the unit.
This wire should be fully unwound and extended at full length for best reception.
8