Invacare LYNX PANTHER LX-4 - Manual (Page 50)

50 50
PROCEDURE 11 REPLACEMENT PARTS - PANTHER MX - 4
R
E
P
L
A
C
E
M
E
N
T
P
A
R
T
S
P
A
N
T
H
E
R
M
X
4
REPLACING TAIL LIGHT CABLES
(FIGURE 3)
1. Remove the rear shroud. Refer to REMOVING/
INSTALLING THE REAR SHROUD in PROCE-
DURE 9 of the Owner’s Manual, part number
1090132.
2. Pull back the plastic guards on the RED and
BLACK cables connecting the tail light cable to
the tail light assembly.
3. Remove the RED and BLACK cable metal con-
nectors of the tail light assembly from the RED
and BLACK cable metal connectors of the tail
light cable.
4. Remove the tail light cable.
5. Position the RED cable connector of the NEW
tail light assembly in the RED cable metal con-
nector of the of the tail light cable.
6. Position the BLACK cable connector of the NEW
tail light assembly in the BLACK cable metal con-
nector of the of the tail light cable.
7. Reposition the plastic guards on the RED and
BLACK cables connecting the NEW tail light
cable to the tail light assembly.
8. Reinstall the rear shroud. Refer to REMOVING/
INSTALLING THE REAR SHROUD in PROCE-
DURE 9 of the Owner’s Manual, part number
1090132.
REPLACING TAIL LIGHT
ASSEMBLY (FIGURE 2)
1. Remove the rear shroud. Refer to REMOVING/
INSTALLING THE REAR SHROUD in PROCE-
DURE 9 of the Owner’s Manual, part number
1090132.
2. Disconnect the tail light assembly from the tail light
cable by performing STEPS 2-3 in REPLACING
TAIL LIGHT CABLE in this procedure of this manual.
3. From outside of the rear shroud, grasp the lock-
ing tabs on the back of the tail light assembly,
and squeeze them together.
4. From outside of the rear shroud, slowly pull the
tail light assembly and the rubber spacer through
steel plate and the holes in the rear shroud.
5. Remove the steel plate from the inside of the rear
shroud.
6. Align the NEW tail light assembly with the hole in
the rear shroud.
NOTE: To ensure the tail light assembly is installed
securely, be sure to position the rubber spacer be-
tween the OUTSIDE of the rear shroud and the tail
light assembly.
7. Push the locking tabs of the NEW tail light as-
sembly through the rubber spacer and through
the hole in the rear shroud until the they “snap”
into place.
8. Thread the cables of the NEW tail light assembly
through the NEW steel plate, and position the
NEW steel plate over the locking tabs on the NEW
tail light assembly
9. Connect the tail light assembly to the tail light
cable by performing STEPS 6-8 in REPLACING
TAIL LIGHT CABLE in this procedure of this
manual.
10. Reinstall the rear shroud. Refer to REMOVING/IN-
STALLING THE REAR SHROUD in PROCEDURE
9 of the Owner’s Manual, part number 1090132.
Locking Tabs
(Squeeze Together)
Tail Light
Assembly
Rear Shroud
Steel Plate
Rubber
Spacer
Cables
FIGURE 2 - REPLACING TAIL LIGHT
ASSEMBLY