IMC Networks AccessEtherLinx/4 - Manual (Page 19)

16
easily upload and store new firmware versions for upgrading multiple devices
with on-board logic installed in, or connected to, an iMediaChassis series.
Using Telnet
Assign the AccessEtherLinX/4 an IP Address or use the default IP Address
10.10.10.10, subnet mask 255.0.0.0 before using a Telnet session. All configurations
done via the serial port can also be performed using Telnet. Use only one Telnet
session at a time. Do not use an RS-232 serial session and a Telnet session at the
same time.
Use Hyper Terminal to access the CLI (Command Line Interface). The manual will
describe how to do this.
Configuring the AccessEtherLinX/4 to Act as a Simple Media Converter
with a Switch
Use Hyper Terminal to access the CLI (Command Line Interface). The manual will
describe how to do this.