IMC Networks AccessEtherLinx/4 - Manual (Page 12)

9
received, the SNMP Management Module will reboot so that the new IP address will
take effect. Refer to the Main Configuration About Serial Port Configuration for more
information about Enabling/Disabling DHCP. When there is no DHCP server on the
network, use iConfig or serial configuration to manually set the IP addresses. When
DHCP is enabled, the IP address (default 10.10.10.10 or user configured) is saved.
When DHCP is disabled, the saved IP address will be reinstated and the device will
reboot. DHCP servers give out lease times: devices renew their leases based on the
administrator-specified time. If a device cannot renew its lease, and the lease
expires, the device will be given the IP address 10.10.10.10 and will reboot.
Ending a Session
Be sure to press E before disconnecting the cable in order to stop the continuous
stream of data to the serial port.
Additional Device-Specific Options
The AccessEtherLinX/4 also includes device-specific options. Press the Space Bar
when in the Command List section of the Main Configuration screen (serial
configuration/Telnet session), type the name of the action, and press Enter.
Device-Specific Configuration Options
The AccessEtherLinX/4 also includes several device-specific options. To access these
options, press the Space Bar from the Command List section of the Main
Configuration screen, type the name of the action you want to perform (as shown
below) and press Enter.