Invacare 75 - Manual (Page 2)

SHOWER CHAIRS 2 Part No. 1089640
ASSEMBLING THE BACK ( FIGURE 1 )
NOTE: If your Shower Chair is not equipped with a back, proceed to ASSEMBLING THE LEGS in this
instruction sheet.
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY of this
instruction sheet.
1. Remove all contents from the package.
2. Insert the back support tube into the back as shown in FIGURE 1.
3. Install mounting screw through back and into the back support tube. Loosely tighten.
Repeat STEPS 2 - 3 for opposite side.
4. Securely tighten both mounting screws.
5. Refer to ASSEMBLING THE LEGS in this instruction sheet.
FIGURE 1 - ASSEMBLING THE BACK
ASSEMBLING THE LEGS ( FIGURE 2 )
NOTE: Refer to INSTALLATION WARNINGS in the SAFETY SUMMARY in this instruction sheet.
1. Position top leg over bottom leg aligning cutouts of both legs. Refer to DETAIL "A" in
FIGURE 2.
2. Install mounting screw through flat washer, top leg, bottom leg and lock washer. Secure
with wing nut.
3. Refer to ATTACHING THE LEGS TO THE SEAT in this instruction sheet.
NOTE: Only adjustable height model
is shown for clarity. The fixed height
models assemble the same way.
Bottom
Leg
Top Leg
Mounting Screw
Flat Washer
Wing Nut
Lock
Washer
Mounting
Screw
Back
Back Support
Tubes
FIGURE 2 - ASSEMBLING THE LEGS
Cutout
Top
Leg
Bottom
Leg
DETAIL "A"