Invacare 6908A - Manual (Page 2)

Invacare Corporation www.invacare.com
USA Canada
One Invacare Way 570 Matheson Blvd E Unit 8 Invacare is a registered trademark of
Elyria, Ohio USA Mississauga Ontario Invacare Corporation.
44036-2125 L4Z4G4 Canada Yes, you can. is a trademark of Invacare
800-333-6900 800-668-5324 Corporation.
© 2004 Invacare Corporation
Part No. 1125025 Rev A - 3/04
MODEL 6908A
Push Handle Pad Kit (Part No. 1124322) contains the following items:
DESCRIPTION QUANTITY
Push Handle Pad 2
REPLACING THE PUSH HANDLE PADS - MODEL 6908A
(FIGURE 2)
1. Remove the top two (2) hex screws
that secure the push handle to the
seat frame.
2. Remove the push handle and cut
either of the two (2) EXISTING push
handle pads that are damaged or
worn, and remove.
3. Clean the push handle and apply a
small amount of dish soap on the push
handle.
4. Note the cut outs on the NEW push
handle pads. They must seat on the
underside of the push handle and fit
around the recline lever.
5. Work the NEW push handle pad onto the push handle until it is completely in place.
6. Using the two (2) existing hex head screws secure the push handle to the back frame
and securely tighten.
FIGURE 2 - REPLACING THE PUSH
HANDLE PADS - MODEL 6908A
Hex Screws
Recline
Lever
Push
Handle
Back
Frame
Push Handle
Pad
Push
Handle
Pad