IKEA FWM7 - Manual (Page 13)

• The selected delay can be changed
only after selecting the washing pro-
gramme again.
• The door will be locked throughout
the delay time. If you need to open
the door, you must first set the wash-
ing machine to PAUSE by pressing
button 5 and wait a few minutes be-
fore opening the door. After you
have closed the door, press the
same button again.
• The Delay Start cannot be selected
with the draining programme.
Start the programme by pressing button 5
To start the selected programme, press this
button; the corresponding green indicator
light stops blinking.
The indicator light 3 illuminates to indicate
that the appliance starts operating and the
door is locked.
If you have chosen a delayed start, the ma-
chine will begin the countdown.
If an incorrect option is selected, the
message Err appears on the display
for a few seconds and the red indicator
light of the button 5 blinks 3 times.
Altering an option or a running
programme
It is possible to change some options before
the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the button
5.
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to O and then to the new pro-
gramme position. Start the new programme
by pressing the button 5 again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button 5 to interrupt a programme
which is running, the corresponding green
indicator light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to O to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing
the button 5.
If the indicator light 3 blinks and after a few
minutes goes off, the door can be opened.
If the indicator light 3 remains lit, this means
that the machine is already heating or that
the water level is too high. In any case, do
not try to force the door open!
If you cannot open the door but you need
to open it, you have to switch the machine
off by turning the selector dial to . After
a few minutes the door can be opened.
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 5.
Caution! Pay attention to the water
level and temperature!
At the end of the programme
The machine stops automatically. Some
acoustic signals sound and a blinking ap-
pears on the display, the indicator light of
button 5 and the indicator light 3 go off.
If a programme or an option that ends with
water left in the tub has been selected, the
indicator light 3 remains on and the door is
locked to indicate that the water must be
emptied out before opening the door.
To empty out the water:
1. Turn the programme selector dial to
.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing button 10.
4. Press button 5.
At the end of the programme, the door is
released and can be opened. Turn the pro-
gramme selector dial to to switch the
machine off.
ENGLISH 13