iHome IA90 - Manual (Page 5)

3
Setting Up the Unit
Connect Unit to Power Source
Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120V AC wall socket. Adaptor must
be plugged in to operate unit. The unit does not operate on batteries (a battery back up system maintains clock settings
during power failures).
Updating firmware on the Unit
For best performance, make sure to update the unit’s firmware. To do so, download the free iHome+Sleep app from the
App Store. Launch the app, then go to Settings/iA90 and follow directions to update the firmware.
Setting the Clock Time Using Time Sync
The Time Sync feature allows you to sync the time setting on the unit to the time on your iPhone or recent model iPod (iPod
touch, iPod nano and iPod Classic; older iPod models such as iPod mini do not support this feature).
1. Press and release the Clock Adjust/Time Sync Button located at the back of the unit. “TIME SYNC” flashes on the display
and a beep sounds.
2. Once sync is completed, “TIME UPDATED” appears on the display followed by 2 beeps indicating time sync is complete.
The updated time will appear on the display.
3. If sync was not successful, “SYNC FAILED” will appear on the display and a long beep will sound. If this happens, please
try again, with a different iPhone or iPod if needed. If sync still fails, please see Setting Clock Manually below to set the
clock.
NOTE: iPhone time is automatically updated to the correct time via cell phone towers. The time on your iPod is accurate only
to the time on the computer the last time the iPod was synced to it. It’s possible to have up to 59 seconds difference between
the unit and synced iPhone/iPod.
Setting Time Zone, Daylight Saving Time, Clock and Calendar Manually
If you want to set the clock manually instead of using the Time Sync feature please proceed as follows:
1. If Daylight Saving Time is now in effect set the DST switch on the back cabinet to the “+1” position. If Standard Time is
now in effect set the DST switch on the back cabinet to the “ – 1” position.
2. The default clock setting is Eastern Time. If you live in the Eastern Time zone no further adjustments are necessary. If you
live in a different time zone press and hold the Time Zone Button on the back cabinet until the unit beeps and “EAST”
appears in the clock display, then press and release the + or – Buttons until your own time zone appears in the display.
Press and release the Time Zone Button to exit the Time Zone setting mode. The unit beeps twice and the display shows
the time in your time zone.
3. Press and hold the Clock Adjust/Time Sync Button on the back cabinet until the time display begins flashing, then press
and release the + or – Buttons to adjust the time display. Hold the + or – Buttons for rapid adjustment, then release
the buttons and press repeatedly to set the display to the exact minute. Observe the AM and PM indicators to make sure
you have set the time correctly. (Note: if you wish to change the time display from the 12-hour format to the 24-hour format,
sometimes called ‘military time’, press and release either the or Button to switch between 12-hour and 24-hour
display formats.)
4. Press and release the Clock Adjust/Time Sync Button again. The Year flashes in the display. Press and release the
+ or – Buttons to set the correct year if necessary.
5. Press and release the Clock Adjust/Time Sync Button again. The Month and Date flashes in the display. Press and
release the + or – Buttons to set the correct month and date if necessary.
6. Press and release the Clock Adjust/Time Sync Button once more to exit the setting mode. The unit beeps twice to confirm
that the time and calendar settings are complete.
NOTE: You can also adjust settings on the unit via the iHome+Sleep app. To do so, press and hold the Button when
the iHome+Sleep app is open and in view. See the iHome+Sleep Start Guide for more information.
P5