Motorola UNIVERSAL BLUETOOTH H9 - Manual (Page 6)

MAKING CALLS
CONTINUED
Function Action
Toggle between two Press and hold
active calls the Call button until
you hear a medium
beep
Join a 3-way call Press and hold
both Volume buttons
until you hear a
medium beep
Put an active call on Press and hold the
hold or resume a call Call button until you
on hold hear a medium beep
Transfer a call from the Tap the Call button
phone to the headset
Transfer a call from the Press and hold
headset to the phone the Call button until
you hear a low beep
Mute or unmute a call Tap both Volume
buttons
Note: Some features are phone/network dependent.
MAKING CALLS
CONTINUED
Function Action
Disable or enable the Press and hold
indicator light both Volume
buttons until you
hear a low beep
AUDIO TONES
The audio tones provide information about your
headset's status.
Audio Tone Headset Status
Single high tone when Volume at minimum
pressing Volume button or maximum
Five rapid high tones Low battery
repeated every 20 sec.
No audio indications; Out of range
deteriorating quality
Ring tone Incoming call
Single very high All calls ended
tone
AUDIO TONES
CONTINUED
Audio Tone Headset Status
Single high tone Tapping Call button
or both Volume
buttons
Single medium tone Pressing Call button
or both Volume
buttons for 1-2 sec.
Single low tone Pressing and holding
Call button or both
Volume buttons for
greater than 2 secs.
Single high tone Phone network not
repeated every 5 sec. available
Two ascending tones Mute enabled
Two descending tones Mute disabled
Four ascending tones Headset powering
on
Four descending tones Headset powering
off
INDICATOR LIGHTS
Indicator lights provide information about your
headset and charger base status.
Charger Base
Indicator Status
Charger Battery On Charging
(
- )
Flashing Battery low
Off Charging complete
Headset Battery On Charging
(
+ )
Off Charging complete
Headset
Indicator Status
Off Power off
On (steady) Pairing mode
10 rapid flashes Pairing successful
Slow pulse Connected (on a call)
Quick flash Standby (not on call)
Note: After 5 minutes of inactivity, the light stops flashing to
conserve power, but the headset remains in standby mode.