Marantz VP-10S1 - Manual (Page 3)

MOUNT10 PROJECTOR MOUNT INSTALLATION INSTRUCTIONS continued
Step 3
Step 2 B
Step 3 B
Figure 3
Figure 4 Figure 6
Figure 5
Step 4
Wire
Access
Wire
Access
1
3
1
2
2
2 2
2 2
2
2
2
3
1
3
Plate 3 Plate 4
Plates 1 & 2 Plate 3
Horizontal Adjustment Plate 2 (Figure 2) attached to
Projector Mount Ceiling Plate 1.
Horizontal Tilting Plate 3 Projector Mounting Plate 4
Install the combined plates (above) securely to the ceiling
structure in accordance with local commercial building
standards.
Use suitable hardware in adequate quantity and size depending
on the installation requirements. (Please note that Projector
VP-10S1 weighs 90.3 lbs. (41kgs).
Attach Horizontal Tilting Plate 3 to the previously combined
plates (already installed on ceiling) using the two (2) 8 (mm)
screws with rubber washers, steel washers and four (4)
6 (mm) screws with washers provided, as indicated in Figure
4. Install two (2) 6 (mm) screws with rubber spacers and
metal washers into the welded metal studs (indicated #1)
Tighten halfway.
Holes for 6mm screws with washer
1
1 1 1
1 1 1
holes for 6mm screws with rubber washers Holes for 8mm screws with rubber washer and steel washer
Holes for 6mm screws with rubber washer and steel washer
Indicates Forward
Positioning of Mount
Indicates Forward
Positioning of Mount
Tilting Capability Tilting Capability
Horizontal Tilting Plate 3 Attached to Plates 1 and 2.
The newly combined Plate 3 provides 8 0 degrees of
horizontal tilt. When positioned, tighten with screws
and washers provided.
12 1/4"
17"
Invert the projector and place it on a soft and flat surface. Align
the six (6) rubber spacers provided with the six (6) 6 (mm)
mounting holes on the projector and secure with the six (6) 6 (mm)
screws provided.
continued over