Marantz CDR300 - Manual (Page 15)

POWER
ON OFF
MIX LINE AUX DIGITAL REMOTE
RC-5 EXT. INT.
FOOT
PEDAL
IN
OUT
IN
OUT
R
L
R
L
IN OUT OUT
DC IN
- 15 -
Controls, Connections (rear)
1 MIX OUT jacks
Plug Right and Left RCA audio
cables in here to connect to the
input of an amplifier or other
external unit. Use for recording
onto an external recorder.
Input from MIC/LINE (or INT MIC)
and/or AUX jacks are output as
MIX
R
L
OUT
line level output to an external recorder or amplifier.
The signal is output before going to the CDR drive, so
it is available for monitoring or recording even if the
CDR drive is stopped. This signal cannot be equalized
by the CDR300 tone controls.
1 2 3 4 5 6 7 8
MIX LINE AUX
R
L
OUT
2 LINE OUT jacks
Plug Right and Left RCA
audio cables in here to
connect to the input of an
amplifier or other external
unit. This signal can be
equalized by the CDR300
tone controls.
AUX
R
L
IN
3 AUX IN jacks
Plug Right and Left RCA audio
cables in here to connect to the
output of an external unit.
Use for recording onto the CDR
drive from an external audio
source such as a cassette deck, or
CD player.
DIGITAL
IN
OUT
4 DIGITAL IN and OUT jacks
Plug RCA coaxial cables in here to
connect to the input and/or output
of an external digital unit.
Use IN for recording onto the CDR
drive from an external digital audio
source.
Use OUT for going to an external
digital device.
5 REMOTE RC-5 IN and OUT
jacks
Plug RCA audio cables in here to
connect to the input and output of
an RC-5 remote control system.
The RC-5 control code list is on
page 34.
REMOTE
RC-5
IN
OUT
Notes:
• For more information on the RC-5 system and
details regarding its operation please contact
Superscope Technologies at (630) 820-4800 or
www.superscope-marantzpro.com.
• When an RC-5 remote control system is not used
the REMOTE EXT. INT. switch should be at INT.
REMOTE
EXT. INT.
6 REMOTE EXT. INT. switch
Switch to EXT. (external) when an
external RC-5 remote control
system is used.
Notes:
• Switch to INT. (internal) to enable the supplied IR
(infrared) remote.
7 FOOT PEDAL jack
An optional foot pedal can provide
Play/Pause control for the CDR drive.
This jack does not perform pause or
continue during recording. Foot pedal
(FT200) is available from Superscope
Technologies at (630) 820-4800 or
www.superscope-marantzpro.com.
FOOT
PEDAL
8 Power plug
Plug one end of the supplied
power cord in here and the
other into an AC outlet.