Morphy Richards Bagged cylinder Vacuum User Manual

Page 9

Overview of the Appliance Components

Operation

Dust compartment lid
Hose inlet
“Dust bag full” indicator
Variable power control
Cable rewind
ON/OFF switch
Dust compartment release
Exhaust filter
Motor protection filter: Plastic foam filter or micro
hygiene filter (depending on the configuration)
Dust bag holder location

1
2
3
4
5
6
7
8
9

Carrying handle

Vacuum hose with air bleed slider
Telescopic tube with accessories holder (depen-
ding on the configuration)
Switchable floor nozzle
Vacuum cleaner bag
Bag holder
Furniture Brush (depending on the configuration)
Upholstery nozzle (depending on the configuration)
Crevice tool
Tube park

11
12
13

14
15
16
17
18
19
20

Switching on

Push the vacuum hose into the hose inlet on the top of the vacuum cleaner so that it is physically locked
in place there.

To remove the hose again, press the button on the vacuum hose attachment piece. Keep this but-

ton pressed and pull the hose out of the vacuum cleaner.

Pull out the power cord to its full length and plug into the mains supply.

Cord Rewind

Press the button with your foot or hand to wind up the cable
WARNING: When rewinding always hold the plug.
.

Make sure that the power control is set all the way to the left to “Min”. To start the motor, press the

“On/Off” switch.

Now, turn the power control to the right until the desired power setting has been reached. Work

with consistent speed when vacuuming. In the process, it is unnecessary to apply additional pressure on
the suction nozzle.
Variable Power Regulator
Low level of suction: for curtains and delicate fabrics.
Medium level of suction: for deep pile velour rugs and broadloom.
High level of suction: for hardwearing carpets and floors.

Telescopic tube

(varies depending on the appliance model)
This adjustable vacuum tube can be lengthened to fit your height to make your work more convenient.
Loosen the locking device by pressing the button in the direction of the arrow. Set the vacuum tube
to the desired length. To lock the vacuum tube in the desired length, release the button and push the
suction tube in a little until you hear the lock click.

Floor nozzle: for vacuuming carpets and smooth surfaces.

Snap the lever forwards for carpets and deep pile fitted carpeting.
Snap the lever backwards for hard floors and hardwearing short pile fitted carpeting.

www.morphyrichards.com