Morphy Richards Bagged cylinder Vacuum - Manual (Page 11)

11
It is recommended to always clean the filer if there is an operational fault, i.e. after the dust bag tears or
after removing a blockage.
ATTENTION: Never use the appliance without the motor protection filter in place or else the
motor could become damaged, which would not be covered by guarantee.
B19 Press the unlocking button of the dust compartment lid and fold down the dust compartment lid.
B20 Pull out the bag holder with the dust bag towards the back.
B21 Remove the filter and clean it by either shaking it out or washing it. When washing the filter,
handle it with care and use warm water. Let it dry in the air. Do not use a detergent. The filter must be
fully dry before reinserting it back into the appliance.
Reinsert the motor protection filter. Make sure that the filter is fastened centrally on the suction grate.
B22 Replace the bag holder with the dust bag and close the lid.
ATTENTION: Never vacuum without a dust bag.
When do I have to change the motor protection filter ahead of time?
When the vacuum cleaner is used improperly such as vacuuming without a paper bag or when the dust
bag tears.
B23 Changing the Exhaust Filter
Press the catch down and rotate the cover complete with filter, away from the cleaner.
B24 The filter configuration varies depending on the appliance model.
Pull the HEPA exhaust filter up and out of the holder. Clean the HEPA exhaust filter by banging it out or
with a soft brush. Afterwards, put the HEPA exhaust filter back into the appliance.
The HEPA exhaust filter must be replaced with a new one after approx. 50 hours of normal operation.
B25 The filter configuration varies depending on the appliance model.
Pull the foam plastic exhaust filter up and out of the holder. Clean the foam plastic exhaust filter by
banging it out, with a soft brush, or by washing it. When washing the filter, handle it with care and use
warm water. Let it dry in the air. Do not use a detergent. The filter must be fully dry before reinserting
it back into the appliance.
B26 Afterwards, put the foam plastic exhaust filter back into the appliance.
The foam plastic exhaust filter must be replaced with a new one after approx. 50 hours of normal ope-
ration.
The filter configuration varies depending on the appliance model.
Foam plastic filter
Cleaning and Service
Unplug the power plug before cleaning and service. The vacuum cleaner – and above all the dust
space – and all the accessories can be cleaned with a soft cloth or commercial plastic cleaner. Let it dry
afterwards.
Occasionally vacuum the lower side of both floor nozzles with the joint and crack nozzle.
www.morphyrichards.com