Marantz CD5400 - Manual (Page 15)

11
ENGLISH
ENGLISH
NAMES AND FUNCTIONS
Rear panel
A ANALOG OUT (analog output) connectors
The music signals during play are output from these
connectors.
B DIGITAL OUT COAX. (digital coaxial output)
connector
The music signals during play are output digitally from
this coaxial output connector.
* Digital signals are not output during pitch control play.
C DIGITAL OUT OPT. (digital optical output)
connector
The music signals during play are output digitally from
this optical output connector.
* Digital signals are not output during pitch control play.
D REMOTE CONTROL IN and OUT connectors
Using the supplied remote control connecting cable, these
connectors enable this player to be connected to a
Marantz component equipped with remote control
connectors. These connections make it possible to control
an entire system that centers on the amplifier or other such
component.
E EXTERNAL/INTERNAL switch
Before the player was shipped from the factory, this switch
was set to INTERNAL to enable the remote sensor built
into the player to be used.
Before using the supplied connecting cable to make the
connection between the player and the remote control
connectors on a Marantz equipment, set the switch to
EXTERNAL.
Note:
Signals cannot be received from the remote control
unit if the switch is kept at EXTERNAL when the player
is to be used on its own.
F AC POWER SOURCE CONNECTION
Plug the mains lead into a mains outlet providing the right
voltage.
L
R
ANALOG OUT
OPT. COAX.
DIGITAL OUT REMOTE
CONTROL
EXTERNAL INTERNAL
IN
OUT
AC IN
A D E B C F
03.4.10, 3:49 PM Page 11