Marantz STRIKER S160 User Manual
Page 18
18
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
T
rouBleshooTing
P
roBlem
s
oluTion
POOR DRAFT:
Extend chimney in length or have the chimney realigned to the proper size flue. Oversized
chimneys normally have poor drafts. Remember, the stoves’ draft depend solely on the natural
draft of the chimney (See Drafting section on page 4). If your stove is not drafting properly,
your chimney is the problem. All stoves are thoroughly tested to insure proper draft with the
correct size chimney flue.
EXCESSIVE DRAFT:
With better chimneys being more common, excessive draft can be an issue. Alleviate excessive
draft by slowing the burn rate of the stove once it has reached proper operating temperature
(See Maximizing Your Stoves Overall Efficiency on page 16).
DIRTY GLASS:
1) Burn smaller, hotter fires and check to make sure you are not setting the draft down too far
with the draft control.
2) Make sure your wood is well-seasoned and dry (not open to rain - see Creosote and Fuel
sections on page 3).
3) See Poor Draft section (above) and Clean Glass on page 15 .
SMOKES WHEN
1) If smoke is entering the room, check to make sure your baffle bricks are properly installed
DOOR IS OPEN:
and that the insulating blanket is pushed back flush with the front of the baffle brick.
2) Check the chimney for blockage due to creosote (see Chimney & Creosote sections on
pages 3 and 4).
3) Check draft (See POOR DRAFT section above).
WOOD BURNS
1) The draft control must be closed further.
TOO FAST:
2) Add fuel at lower firebox temperatures.
3) Load wood side to side and reduce the flow of air under wood.
4) The door seal may need replacing, check for leakage.
5) See “Excessive Draft.”
POOR HEAT
1) Check your wood. Wet, moist, unseasoned wood will not produce heat.
OUTPUT:
2) Your stove needs to be seasoned (moisture removed from the steel and brick). Continue
to burn a fire. It normally takes from one to three weeks of burning to season your stove (See
Break-in Procedures on page 5).
3) See Excessive Draft section above.
PAINT GIVES OFF
Paint is tempering-in. Burn only moderately hot for the first few days until paint is fully cured.
ODOR (smoke):
Then burn a very hot fire to cure any paint that may not easily cure. Open windows or door to
ventilate (See Break-in Procedures on page 5).