Mitsumi electronic MAC 12 - Manual (Page 7)

6
GB
Installation
The terminals are connected to FX0, FX0N or
FX PLC system.
Connection to a FX0/FX0N
PLC system
Connect the MAC 10/12-CAB (8-pin MINI-
DIN) cable to the outlet in the bottom of the ter-
minal. The cable is straight; the contact at each
end is compatible with both the terminal and the
PLC system. The cable has a maximum length
of 3 m and the communication speed is 9600
baud. The terminal is powered by the PLC
system via the cable supplied. If a longer cable
is required, the terminal must be powered from
a source other than the PLC system.
M I T S UBI SH I
M E L S E C F X 0
Mac10eng Seite 6 Freitag, 5. Februar 1999 3:29 15