Marantz VP-11S1 - Manual (Page 18)

10
ENGLISH
You can connect this projector to HD-Video /PC using RGB IN port, or DVD Plyer /Satellite /Cable Tuner
/PC using HDMI IN port.
1. Connect one end of the RGB cable to the RGB IN port, or one end of the HDMI cable to the HDMI IN
port on the projector.
2. Connect the other end to the corresponding port on a HD-Video, Satellite, Cable Tuner or personal
computer.
3. If using DVI-A or DVI-D output, use respectively a DVI-A-RGB or DVI-D-HDMI conversion cable.
Note : When projecting a video image from a device connected to the HDMI terminal, follow the
procedure below.
1. Turn on power of this unit. (
☞
P.16)
2. Set the input video source to HDMI input. (
☞
P.16)
3. Turn on power of the device connected to the HDMI terminal of the unit (i.e. DVD player).
If the procedure above is not followed, projected image may corrupt.
For the details of the HDMI terminal on the device connected with the unit, see the instruction
manual of the device.
Connection with a HD-Video, DVD Player, Satellite, Cable Tuner or PC
RGB OUT
or
DVI-D out
RGB OUT
or
DVI-D out
RGB (D-Sub monitor) cable
(commercially available)
HD-Video / Satellite /
Cable Tuner / DVD Player
Monitor output
IBM VGA or
Compatible PC
RGB OUT
or
DVI-A OUT
DVI-D OUT
or
HDMI OUT
HDMI-HDMI cable or HDMI-DVD-D cable
(commercially available)
RGB out
or
DVI-D out
You can control total home theater system using PC or Marantz receiver equipment.
For installing below system, consult with Marantz authorized dealer.
Advanced Connection
REMOTE CONTROL IN
REMOTE CONTROL OUT
RS-232C cable
(female-female, straight type,
commercially available)
External Controller
Screen
3.5mm Mini Plug (Mono)
(commercially available)
Control Adapter cable
(commercially available)
Receiver equipment
Control Adapter cable
(supplied)