Marantz VP-15S1 - Manual (Page 28)

20
ENGLISH
• Press the ZOOM button, the NORMAL button or the FULL button on the remote controller for the 4:3
aspect ratio video source.
• Press the FULL button on the remote controller for 16:9 aspect ratio video source, such as 1080i,
1035i, and 720p video systems.
• Use Zoom mode when projecting a 480i, 480p, 576i, or 576p squeezed image with a 2.35: 1 aspect
ratio.
• Use V-Stretch mode when projecting a 720p, 1080i, or 1080p squeezed image with a 2.35: 1 aspect
ratio.
The Screen Images in a 4:3 screen
❖
Original Source Image
❖
Full mode
The 16:9 squeezed image is displayed with the
correct aspect.
❖
Normal mode
❖
Zoom mode
A 2.35:1 image is displayed in the entire screen.
This function is best used when a 480i, 480p,
576i, or 576p squeezed image is input.
16 : 9 video source
The 4:3 image is enlarged horizontally.
The picture in normal ratio 4:3 is displayed.
4 : 3 video source
❖
Through mode
Images are shown at the same resolution as RGB/video signals.
1. Press the STANDBY button on the remote controller or the / I button on the projector.
2. The fan continues running for about 1 minute to internally cool the projector. In the meantime, the ON
indicator on the projector flashes a blue color and buttons on the projector and remote control are
irresponsive to touch. Once the fan stops, the ON indicator goes out and the STANDBY indicator
lights up a green color to indicate the projector is on standby.
Notes :
- Do not pull out the AC power cord until the projector turns in standby mode.
- Do not pull out the power cord suddenly in the state of “POWER ON." It can cause a breakdown.
- If the WARNING indicator lights up or blinks a yellow color, check that the fan has stopped then
unplug the AC power cord from its outlet.
- The projector will not be turned on if the ON button on the remote controller or the / I button on
the projector is pressed immediately after turning off. Press the ON button on the remote controller
or /
I button on the projector after the projector turns into standby mode.
- When on standby, power to the projector is not OFF completely. If not planning to use the projector
for an extended period of time, unplug the AC power cord from AC power outlet as explained above.
C1 C2 S G1
H1 H2 V G2
A1 A2 RGB G3
COMP.1 COMP.2 S-VIDEO USER
HDMI 1 HDMI 2 VIDEO
AUX 1 AUX 2
ON STANDBY
IRIS LAMP C.TEMP GAMMA
To Turn off the Power
❖
V-Stretch mode
The 2.35:1 image is shown across the entire screen. This function is best used when a 720p, 1080i, or
1080p squeezed image is input.