MicroBoards Technology CD Disc-to-Disc Office Copier II - Manual (Page 25)

Orbit II Disc-to-Disc Copier Reference Manual – Revision I
25
6.0 Basic Orbit II Operations :
Orbit II was designed to be as easy to use as an office copier for paper documents. Making copies of a
master CD takes only a few simple steps; load the number of blank discs you want to copy, select Copy
CD-to-CD? by pressing the Yes key, insert your master in Orbit II’s CD Reader, and press the Yes key
again. Orbit II will copy the master disc on to blank CD-R or blank CD-RW discs until its Input Hopper is
empty. Because all operating mechanisms are fully enclosed; you can add discs to the Input Hopper,
remove discs from the Accept Basket, or remove Discs from the Reject area at any time. Your master disc
can be a CD, CD-R, or CD-RW disc. There are three Orbit II operating modes, Copy CD-to-CD?, Copy &
Compare?, and Compare CD?.
There are two different ways you can set up your Orbit II, depending upon how you intend to use it. If Ask
Quantity? is turned on, Orbit II will ask the operator how many discs should be processed for each job. In
this operating mode you can leave a stack of blank CD-Rs in the Input Hopper. Orbit II will always provide
the requested number of discs, even if some discs are rejected during the job. If Ask Quantity? is turned
off, Orbit II will not request a quantity from the operator. Orbit II will expect the operator to place the proper
number of discs in the Input Hopper before starting the job. If there are rejects, and a specific quantity of
discs is needed, the operator will have to add additional discs during the job, or set up another job when
the first job is complete. See Section 7 for additional details on the Ask Quantity? option.
6.1 Copy CD-to-CD?:
This Orbit II operating mode is the easiest to use because it is the main menu selection that Orbit II
presents when it completes its power on self-test. A “copy only” operation is the most common form of CD
duplication. In Copy CD-to-CD? mode Orbit II does not verify the content of each data sector recorded.
The example shown below assumes Ask Quantity? is turned on.
To initiate a Copy CD-to-CD? operation:
• Make sure there are enough blank CD-R or CD-RW discs in the Input Hopper.
• Press the Yes key at the prompt.
• When the
prompt appears, use the Yes and No keys to
set the required number of discs in Orbit II’s counter. Pressing the Yes key accepts the
number above the underline cursor, and tells Orbit II you are ready for the next operation.
Pressing the No key increments the number above the underline cursor. (If you accidentally
press the Yes key at the “10s” digit and move to the “1s” digit before you are ready, you can get
the cursor back to the “10s” digit by pressing the No until the “1s” digit changes from “9” to “0”.)
Quantity? 00
Copy CD-to-CD?
• When the CD Reader tray opens, place your master in the CD Reader tray and press Yes .
• Orbit II will copy the master disc on to the blank discs until the requested number of discs are
accepted.
• You can add discs to the Input Hopper, remove discs from the Accept Basket, or remove Discs
from the Reject area at any time.