MicroBoards Technology CD Disc-to-Disc Office Copier II User Manual

Page 24

Orbit II Disc-to-Disc Copier Reference Manual – Revision I

Verify the distribution disc was copied properly:

• Take the distribution disc copy from the Accept Basket and place it in the Input Hopper.

• Press the No key at the

and or

prompts.

Copy CD-to-CD?

Copy & Compare?

• Press the Yes key at the

prompt.

• When the

prompt appears, press Yes to accept the “10s”

digit setting of “0”. The underline cursor will move to the “1s” digit. Press the No key once
to set the “1s” digit to “1”. Press Yes to accept the “1s” digit setting of “1”.

Quantity? 00

Compare CD?

• When the CD Reader tray opens, place the Orbit II distribution disc in the CD Reader tray and

press Yes .

• Orbit II will compare the master distribution disc to the copy, and place the copy in the Accept

Basket if it passes the content verification test.

You can use this same test sequence to troubleshoot problems with your Orbit II System prior to calling for
technical assistance. If you are trying to isolate media quality problems, substitute reference media for
discs that have a high reject rate. If you suspect problems with a particular master, substitute a reference
master. (You can use your distribution disc as a reference master.) If the term “reference media” or
“reference master” is new to you, refer to Sections 3 & 4 of this manual.

When your Orbit II System passes the disc handling, writer, and reader tests it is ready for use. Proceed to
Section 6 Basic Orbit II Operation.

If your Orbit II System does not pass the disc handling, writer, or reader test contact your Microboards
Technology Technical Support for assistance.