GoVideo DHT7100 User Manual
Page 8

2
DVD System User’s Guide
S T E P 1 - U N P A C K
Before you begin, make sure the following
accessories are included in your DHT7100
packing case:
• Remote Control
• AM Loop Antenna
• FM Antenna
• Video cable
• User’s Guide
• Warranty Card
S T E P 2 - I N S E R T R E M O T E
B A T T E R I E S
1. Remove the battery cover on the back of
the remote by pressing down and sliding
the cover in the direction of the arrow.
2. Insert two 1.5V AAA batteries, paying
attention to the correct polarities (+ and
–).
3. Replace the battery cover.
S T E P 3 - C O N N E C T V I D E O T O T V
C o m p o s i t e V i d e o ( G o o d Q u a l i t y )
Connect the supplied video cable from the
VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your
television.
S - V i d e o ( B e t t e r Q u a l i t y )
If your television is equipped with an S-
Video input, connect an S-Video cable (not
supplied) from the S-VIDEO OUT jack on
the back panel of the system to the S-
VIDEO IN jack on your television.
C o m p o n e n t V i d e o ( B e s t Q u a l i t y )
If your television is equipped with Compo-
nent Video inputs, connect a component
video cable (not supplied) from the Pr, Pb
and Y jacks on the back panel of the system
to the corresponding jacks on your televi-
sion.
Component
Video
Insert two 1.5V AAA batteries.
S-Video Composite
Video