Stovax F40 - Manual (Page 13)

IF THERE IS STILL NO DEFINITE FLOW, THE FLUE MAY
REQUIRE ATTENTION - SEEK EXPERT ADVICE.
2.15 The flue system may now be connected to the stove, ensure
that all joints are sealed with a suitable fire resistant sealant.
It is also recommended that a physical retention method be
used at the flue spigot joint, self-tapping screws being
favoured.
2.16 Connect a suitable pressure gauge to the test point located
on the inlet fitting, and turn the gas supply on. Light the
stove and check all gas joints for gas soundness. Turn the
stove to maximum and check that the supply pressure is as
stated on the data badge. Turn the gas off and replace the
test point screw, turn the gas on and check the test point for
gas soundness.
3.1 Place the flame baffle onto the burner and push against the
rear tray lip. See diagram 11.
3.2 Locate the rear panel against the spacer brackets and slide
down so that it locates on the ledge of the flame baffle. See
diagram 12.
3.3 Locate the front coal between the heat shield and the flame
baffle so its ends sit flat on the burner skin. See diagram 13.
3.4 Place five of the loose round coals on the front coal so they
lean against the flame baffle, in between the fingers. Place
the two rectangular coals against the reflector panels, one
either side, behind the front row of loose coals. See
diagram 14.
3.5 Place four of the loose round coals behind the first row so
that they sit on the fingers, the two outer ones should touch
the rectangular coals. See diagram 15.
3.6 Place the three remaining coals behind the centre row so
that they touch the back panel. See diagram 16.
4.1 After laying out the coals, replace the glass panel. Tighten
the six pozidrive screws, working from the top down. Do
not over tighten. Lower the front door on by holding at 90
degrees to the appliance and lowering down on to the two
hinge pins. See diagram 17.
3. FUEL BED ARRANGEMENT
13
INSTALLATION INSTRUCTIONS
INSTALLATION
12
13
14
15
16
AR0361
AR0362
11
AR0363
AR0364
AR0360
AR0359
4. DOOR REPLACEMENT
17
AR1363