Fujitronic Programmable Operation Display UG520H-x - Manual (Page 2)

Thank you for selecting the Fuji Programmable Operation Display, POD UG520/420/
320/221/220 Series (called as the UG20 or POD, hereafter).
For proper set-up, you are requested to read through this booklet to understand more
about the product.
For more information about UG20 series, refer to the Reference Manual.
For further details about the PLC, see the manual attached to each PLC.
[Reference]
In addition to this manual, the following manuals on the UG20 Series are available.
Please ask your nearest dealer for the appropriate manuals and read them as required.
UG Series
Preface
Name Manual No. Contents
UG Series Manual FEH375 Describes how to operate screen editor
(UG00S-CW) for the UG Series.
UG Series Manual FEH376 Describes the functions of the UG
Series.
UG Series Manual Describes the procedures for communication
FEH355 with PLCs using the optional CC-Link interface.
UG Series Manual Describes the procedures for communication
FEH356 with PLCs using the optional T-Link interface.
UG Series Manual Describes the procedures for communication
FEH357 with PLCs using the optional SX-Bus interface.
UG Series Manual Describes the procedures forcommunication
FEH358 with PLCs using the optional OPCN-1 interface.
UG Series Manual Describes the variable name cooperation function
Name Cooperation Function> FEH363 to be used between the UG editor and D300win.
UG Series Manual Describes the procedures for communicating
FEH366 via the optional ETHERNET interface.
UG Series Manual Describes the procedures for communicating
FEH367 via the optional FL-Net interface.
UG Series Manual Describes the procedures for communicating
FEH368 via the optional PROFIBUS interface.
UG Series Manual The Functions and instructions of the Ladder
Monitor Specifications> FEH379 Monitor are explained.
[Notes]
(1)This manual may not, in whole or in part, be printed or reproduced without the prior written consent
of Fuji Electric Co., Ltd.
(2)Information in this manual is subject to change without prior notice.
(3)Windows and Excel are registered trademarks of Microsoft Corporation in the United States and other
countries.
(4)All other company names or product names are trademarks or registered trademarks of their respec-
tive holders.
(5)This manual is intended to give accurate information about POD hardware. If you have any ques-
tions, please contact your local distributor.