Fostex VF08 - Manual (Page 18)

6. If you agree to the message contents, press the
[ENTER/YES] key.
After showing “Set Enable!” , the display shows the screen
for selecting the song(s) to be loaded.
If there is more than one track recorded on the audio
CD, “ ” flashes, showing that you can select a desired
track. If there is only one track recorded on the audio
CD. “ ” is not shown on the screen.
7. Use the [JOG] dial to select a track number to be loaded
and press the [ENTER/YES] key.
The destination program number starts flashing, which
is one greater than the highest program number among
those available on the current drive. This means a track
is going to be loaded to a new program.
For example, if there are 4 programs available on the
current drive, the destination program number(s) on
the current drive and then perform step 7 above again.
If there are already 99 programs on the current drive,
“Disk Full!” appears and no destination program
number is shown. In such a case, delete the
unnecessary program(s) on the current drive and then
perform step 7 above again.
When loading data using the S/P DIF digital signal,
the same message also appears after selecting the
load device to
“SP DIF” and pressing the [ENTER/YES]
key.
flashing
If you do not agree with the warning message con-
tents, press the
[EXIT/NO] key to quit loading.
The display briefly shows “Set Disable” and “ Can’t Load-
ing” , then returns to the mode select screen.
If you agree with the warning message contents, go
to the next step to continue the operation.
By rotating the [JOG] dial, you can select “NON” , as weel
as a “Program” . When performing the load operation,
tracks that are set to “NON” are not loaded.
8. While the program number is flashing, press the
[ENTER/YES] key.
The flashing program number changes to light solidly,
showing that the first track is ready to be loaded to the
program.
To load more than one track, repeat steps 7 through 8
above.
The following screen example shows that tracks 1 and 2
will be loaded to program 05 and 06 respectively.
The track time is also shown to the left of each program
number.
If you are going to load tracks 1 and 3 in the example
above, instead of tracks 1 and 2, track 3 will be loaded
to program 06 (see the screen example below).
However, if you select track 2 after selecting tracks 1
and 3, the VF08 automatically reassigns track 2 to
program 06 and track 3 to program 07 (see the screen
example below).
9. After specifying track(s) to be loaded, press the
[ENTER/YES] key while holding down the [RECORD] key.
The VF08 starts loading tracks to the current drive.
The following screen example shows that track 1 is now
being loaded to program 08 on the current drive.
When loading from a audio CD, no title is shown when
selecting the track.
When the loading ends, “Load Completed!” appears on
the screen, while the disc is automatically ejected from
the CD-RW drive.
10. Press the [EXIT/NO] key to quit the Setup mode.
The display returns to the Normal display that was shown
last time before entering the Setup mode.
18