Loading backup data from a cd-rw drive, Hint 2 – Fostex VF08 User Manual
Page 12
2. Press the [SETUP] key to enter the setup mode.
The display shows the screen for selecting the setup menu.
In the following procedure, we assume that a CD-RW
drive is connected to the SCSI port of the Model 8340
installed in the VF08 and a CD-RW/CD-R disc to which
data has been saved is prepared.
4. While “SCSI” is flashing, press the [ENTER/YES] key.
After briefly showing the model name of the connected
CD-RW drive, the display shows the screen for selecting a
load mode, where
“BkUp”
(backup) is flashing.
To load song data saved, select
“BkUp”
.
To load a material from an audio CD, select
“CD-DA”
.
This procedure describes how to load song data, so we
select
“BkUp”
here.
See
“Loading from an audio CD”
described later for details
about how to load a material from an audio CD.
3. Use the [JOG] dial to select (highlight) “Load PGM” and
press the [ENTER/YES] key.
The display shows the screen for selecting a load device,
where
“SCSI”
is flashing.
Loading backup data from a CD-RW drive
Do not carry out any VF08 key operation until the
access process to the CD-RW/CD-R disc is com-
pleted.
If you load song data which is saved to more than
one disc, set DISC-1 first.
If you set the other disc and go on the following
procedure, the VF08 automatically recognized
that the disc order is not correct and the display
shows
“Wrong Disk”
, followed by
“Illegal No!”
momen-
tarily, and the disc is automatically ejected.
1. After turning on both the VF08 and the CD-RW drive
connected, insert the disc to the CD-RW drive.
flashing
If you try to save data to a recorded CD-R disc, the
display shows a warning message saying
“Not Writ-
able”
, followed by a message saying
“Insert Disk”
as
below.
• To eject the disc
Use the
[JOG]
dial to highlight
“Eject”
(flashing) and
press the
[ENTER/YES]
key.
The disc is ejected while the display shows
“Insert
Disk!”
.
By inserting a disc, you can start the save opera-
tion again from the beginning.
5. While “BkUp” is flashing, press the [ENTER/YES] key.
The display shows the backup number and title, as well
as recorded space.
12
flashing