Fujitsu Siemens Computers lifebook S6010 - Manual (Page 6)

6
L i f e B o o k S S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed. Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options Default Description
Type: ■ Auto
■ None
■ CD-ROM
■ SuperDisk
■ Hard Disk
[Auto] Selects the ATA/ATAPI device type. Select Auto to have the type auto-
matically identified by the BIOS at POST. If None is selected, all of the
following Set-up items do not appear. Select CD-ROM if a CD-ROM
drive is installed at this connection. Select SuperDisk if a SuperDisk drive
is installed at this connection. If Hard Disk is selected, you must specify
the number of Cylinders, Heads, and Sectors for the drive.
Cylinders: ■ A number between
0
and 65,535
–— This item appears only when Auto is selected and the type is
identified as hard disk, or User is selected. When User is selected, you can
change the value. This field is changed by incrementing (pressing the
[Spacebar]) or by typing in the number.
Heads: ■ A number between
1
and 16
–— This item appears only when Auto is selected and the type is
identified as hard disk, or User is selected. When User is selected, you can
change the value. This field is changed by incrementing (pressing the
[Spacebar]) or by typing in the number.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Primary Master [HITACHI-DK23DA-20-(PM)]
Type: [ Auto ]
Maximum Capacity: 40008MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
PIO Transfer Mode: [Fast PIO 4]
DMA Transfer Mode: [Ultra DMA 5]
▲
Laurel BIOS.fm Page 6 Thursday, May 23, 2002 10:05 AM