Furuno FS-1562-15 - Manual (Page 21)

-1.13-
1.8 In the Event of Antenna Coupler Failure
HIGH TENSION HAZARD
DO NOT TRANSMIT WHEN ATU IS OPENED
The Antenna Coupler automatically tunes a wire or whip antenna to the transceiver. When the
tuning cannot be completed for all frequencies, TUNE OK will not appear on the operation
display. In this case, you can take tuning on 2182 kHz by manually operating Coupler as below:
1. Turn off the transceiver unit. Remove the cover of the Antenna Coupler.
2. Set the MANUAL-AUTO switch to the MANUAL position.
COUPLER BOARD
DUMMY
LOAD
BOARD MANUAL AUTO
3. Replace the cover.
4. Turn the FS-1562 on and press the [2182] key for selection of 2182 kHz.
1.9 DSC Distress Calling
■ When connected to a Digital Selective Calling (DSC) terminal having the capability of
controlling the FS-1562 such as FURUNO DSC-6:
1. Press the [DISTRESS] key on the DSC Terminal (Model DSC-6 for instance).
2. When a coast station acknowledges the call, the DSC Terminal displays “Received Dist Ack”
and sets the predetermined DISTRESS frequency (2182 kHz) on the FS-1562.
3. Communicate with the coast station.
■ When connected to a DSC Terminal without remote control:
1. Select 2187.5 kHz on the FS-1562. (This step is not required with Furuno DSC-6.)
2. Press the [DISTRESS] key on the DSC Terminal. The DSC distress signal is transmitted over
2187.5 kHz.
3. After the DSC terminal notifies that a coast station has acknowledged the call, press the [2182]
key on the FS-1562.
4. Communicate with the coast station.
NOTE: For details of distress calling by a DSC Terminal, refer to the operator’s manual for the
DSC Terminal.