Furuno 1932 MARK-2 - Manual (Page 15)

2-4
2.4 Exchange of Fuse for
24/32V Power Supply
The power cable comes with a 10A fuse in
its the fuse its holder. This fuse is for use with
a 12V DC power supply. For 24V/32V DC
power supply, replace the fuse with the 5A
fuse (supplied) and attach 5A label (supplied)
to fuse holder.
CAUTION
Use the proper fuse.
Use of an improper fuse can damage the
equipment and void the warranty.
2.5 Checking the Installation
After completing the installation, it is a good
idea to recheck it to be sure all steps were
correctly done. Use the table below to check
the installation.
❑ The signal cable is securely retained
against the mast or mounting platform and
is free of interference from running rigging.
❑ The cable gland or entry on the deck, if
provided, is waterproofed.
❑ The power connections to the battery are
of correct polarity.
❑ The plugs at the rear of the display unit
are tightly fastened.
❑ The fuse in the power cable is 10A (12V)
or 5A (24V/32V DC).