Furuno SC-120 - Manual (Page 33)

2. INSTALLATION
2-19
2.6 Initial Settings
Follow the procedures in this section to enter initial settings.
NOTICE
Improper menu settings may stop output of
data and display the message "RATE
ERROR." Be sure to enter correct data.
2.6.1 Confirming satellite status; choosing mounting method
1. Turn on the processor unit and press the [MENU] key to show the menu.
MAIN MENU
SATELLITE
DGPS
I/O SETUP
INST MENU
ERASE
TRIP MENU ALARMS
MESSAGES
GPS SETUP
SYS SETUP
SOFT VER.
OTHERS
Main menu
2. Use the Omnipad ( ) to choose “INST MENU” and press the [ENT] key.
INSTALLATION SETUP
MOUNTING : FLOOR
DIRECTION : A
LANGUAGE : ENG
Installation setup menu
3. Confirm that “MOUNTING” is selected and press the [ENT] key.
4. Use the Omnipad to choose the mounting method: “FLOOR”, “WALL” or
“INVERT” as appropriate.
5. Press the [ENT] key.
6. Choose “DIRECTION” and press the [ENT] key.
7. Use the Omnipad to choose mounting direction (“A ”, “B ”, “C” or “D”) as
appropriate. Refer to section 2.3.1.
8. Press the [ENT] key.
9. Press the [SAT STATUS] key.
SAT TRACKING STATUS
TIMER 5 '52" OK
NO. GOOD STATUS
GPS1 8 8 D3D
GPS2 7 7 D3D
GPS3 8 8 D3D
Satellites
being
tracked
Satellites used for
measurement
"3D" shown when no
beacon receiver is used.
"OK" displayed when
the "GOOD" column
shows that the number
of satellites acquired is
five or more.
Satellite tracking status display