FUJITSU 32-Bit Microcontroller MB9B500 Series - Manual (Page 11)

3.2 On-Board Programming via USB
„ First check the hardware setting as introduced by section 2.4.
„ After connect with PC via USB cable, the EVB can be identified as a USB device.
Figure 3-4: USB Device Sign
„ Check the COM port for this USB port in the device manager.
Figure 3-5: COM Port in Device Manager
„ Install the USB programmer: USBDW_V01L03. (It can be downloaded on the web)
„ Open it, set the parameter as shown in following figure, and select Hex file.
Figure 3-6: USB Programmer Overview
„ Click Full Operation.
Figure 3-7: Press Reset Button
11