Furuno ETR-30N - Manual (Page 3)

ii
The transducer cable must be handled
carefully, following the guidelines
below.
•
Keep fuels and oils away from the
cable.
•
Locate the cable where it will not be
damaged.
•
The cable sheath is made of chloro-
phrene or polychloride vinyl, which
is easily damaged by plastic solvents
such as toulene. Locate the cable
well away from plastic solvents.
Use the correct fuse.
Use of a wrong fuse can cause serious
damage to the equipment.
Be sure to enter transducer model
correctly.
Incorrect setting may damage the
transducer.
Do not enter transducer type manually
if the transducer type is programmed
into the equipment.
Damage to the transducer may result.
WARNING LABEL
A warning label is attached to the equip-
ment. Do not remove the label. If the
label is missing or illegible, contact
a FURUNO agent or dealer about
replacement.
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Name: Warning Label (1)
Type: 86-003-1011-1
Code No.: 100-236-231
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Ground the equipment to
prevent mutual interference.
Do not allow warm water or any liquid
other than seawater or freshwater to
contact the transducer.
Damage to the transducer may result.
Do not install the transducer where
noise or air bubbles is present.
Performance will be affected.
Standard
compass
Steering
compass
ETR-30N 1.7 m 1.1 m
CAUTION CAUTION