beautypg.com

Sub-ts7 – Harman-Kardon HKTS 5 OM User Manual

Page 5

background image

SUB-TS7 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS 5

SUB-TS7 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS

OFF

ON

AUTO

ON

FILTER

NORMAL

REVERSE

PHASE

IN

OUT

AC 120V~60Hz

POWER

"WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE T 2.5A L/250 VOLT FUSE"

"AVERTISSEMENT: UTILISEZ UN FUSIBLE DE RECHANGE DE MEME
TYPE T 2.5A L/250V"

R

L

LINE

LEVEL

IN

MAX

MIN

IMPORTANT: CONNECT STRIPED WIRE
TO RED ( ) SPEAKER TERMINAL.

L

R

SUBWOOFER

LEVEL

SUB-TS7

For use with
HKTS 7 System

R ISK OF ELEC TR IC SH O C K

D O NO T OPE N

C A U TIO N

R ISK OF ELEC TR IC SH O C K

D O NO T OPE N

C A U TIO N

R ISK OF ELEC TR IC SH O C K

D O NO T OPE N

H

I

G
H

L
E
V
E
L

SUB

¡

£

¢

§


ª

¡ Subwoofer-Level Control: Volume
may be adjusted using the Subwoofer-
Level Control. Turn the control clockwise
to increase the SUB-TS7’s volume, or
counterclockwise to decrease it.

™ High-Cut (Low-Pass) Filter Switch:
Placing this switch in the

ON position acti-

vates circuitry that cuts out all audio input
signals above 120Hz. This allows the SUB-
TS7 to focus its power on reproducing the
low-frequency portion of the signal, avoiding

inefficiency and distortion. Engage this filter
when using the Speaker-Level Inputs

•,

or when using the Line-Level Full-Range
Inputs

§, unless your receiver or processor

processes its line-level output using a low-
pass filter. The filter has no effect when the
SUB Input

∞ is used.

£ Music-Sense On/Off Switch: When
placed in the

AUTO position, and when the

Master Power Switch

ª is turned on, the

SUB-TS7 will automatically turn itself on or

place itself in the Standby mode, depending on
whether it is receiving an audio signal. When
this switch is placed in the

ON position, the

SUB-TS7 will remain on, whether or not it is
receiving an audio signal.

An LED located on top of the SUB-TS7 indi-
cates whether the SUB-TS7 is in the ON or
STANDBY state when used with the Music-
Sense On/Off Switch

£ in the AUTO

position. The LED is lit blue to indicate that
the SUB-TS7 is receiving an audio signal

¡ Subwoofer-Level Control
™ High-Cut (Low-Pass) Filter Switch
£ Music-Sense On/Off Switch
¢ Phase Switch

∞ Line-Level Subwoofer (SUB) Input
§ Line-Level Full-Range Inputs
¶ Speaker-Level Outputs
• Speaker-Level Inputs

ª Master Power Switch
‚ AC Power Cord

HKTS 7 OM 11/4/03 11:30 AM Page 7