haier HDY-D70-E - Manual (Page 7)

12
1.Cleaning the surface
Wipe the body of the dryer and the control panel with a damp cloth.
Remember not use any organic solvent or corrosive agent to avoid
damage to the machine.
2. Cleaning the filter screen
To ensure a good ventilation during drying,
the filter screen must be cleaned after every
drying program is complete.
Open the door and remove the filter screen
from the machine. Open the screen and clean
off the dust on the screen with a wet towel. After
cleaning, put the screen back in place.
3. Emptying the water collection box
During operation , steam condenses into
water and is collected in the box.The box must
be emptied after the program is complete.
-Hold the handle and pull the box outwards to
remove it. keep it level to prevent the water
from overflowing;
-Pour away water. Note: the
water can not be used for drink or for food
processing;
-Put the box back in place.If the box has not
been emptied, the dryer will sound an alarm
when the box is full. The indicator light comes
on while the box is emptied and the dryer will
stop. It will not restart until the box is emptied.
4.Cleaning the condenser
The condenser must be cleaned monthly.
Switch off the power supply before cleaning.
-Hold the protrusions on both sides of the
lower deco panel and open it.
13
-Using a coin or other tool, push the slides on the cover to the position
as shown in the figure and then remove the cover;
-Turn the condenser's handle 90 degrees in the direction as shown in
the figure;
-Remove the condenser from the dryer;
-Clean the condenser with a brush or flush with by a water jet;
Note: Do not use a sharp tool in cleaning the heat exchanger, otherwise
it may damage its sealing performance;
-Put the condenser back in place and lock up the cover;
-Put the lower deco panel back in place.
5. Cleaning the drum
After the dryer has operated for
a time, fabric caring agents or
calcium contained in the water will
form an almost invisible layer on
the inside of the drum.
This makes the dryer not able to
reliably and accurately identify the
dryness of the laundry. So the inside
of the drum, especially the stainless
steel pieces on the blades must be
cleaned regularly by a wet cloth.
B C D
A
Cleaning and Maintenance Cleaning and Maintenance