Hitachi DV14DMR - Manual (Page 20)

English
20
CAUTION:
● Do not attach the tip tool except phillips bit to the tool main unit when carrying the
tool main unit with the hook suspended from a waist belt.
Injury may result if you carry the equipment suspended from the waist belt with sharp
tipped components such as drill bit attached.
The hook can be installed on the right or left side
and the angle can be adjusted in 5 steps between
0° and 80°.
(1) Operating the hook
(a) Pull out the hook toward you in the direction
of arrow (A) and turn in the direction of arrow
(B). (Fig. 7)
(b) The angle can be adjusted in 5 steps (0°, 20°,
40°, 60°, 80°).
Adjust the angle of the hook to the desired
position for use.
(2) Switching the hook position
CAUTION:
● If the tool falls, there is a risk that malfunction and/
or physical damage can occur. It is recommended
that you also use fall-preventing wires, etc.
● Incomplete installation of the hook may result in
bodily injury when used.
(a) Securely hold the main unit and remove the
screw using a slotted head screwdriver or a
coin. (Fig. 8)
(b) Remove the hook and spring. (Fig. 9)
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 8)
NOTE:
Pay attention to the spring orientation. Install the spring
with larger diameter away from you. (Fig. 10)
1.1 Using the bit holder (Hook with bit holder)
⅜ Installing the bit
Slide the bit from the side, and then insert firmly
until the groove on the bit locks in the protruded
section of the hook.
⅜ Removing the bit
Securely hold the main unit and pull out the bit
by holding the tip with your thumb. (Fig. 11)
CAUTION:
● Only Hitachi STANDARD ACCESSORIES phillips
bit (No. 2
× 65L; Code No. 983006) may be used.
Do not use other bits since they may come loose.
4
(B)
Fig. 9
Fig. 7
Fig. 8
Loosen
Spring
Hook
Screw
Screw
Larger diameter faces away
Fig. 10
Fig. 11
3
2
1
5
Hook
(A)