Hotpoint E6004 - Manual (Page 11)

11
Electrical Connection
Electrical Connection
THIS APPLIANCE MUST BE EARTHED.
The installation procedure must be carried out by a qualified
electrician.
The electrical safety of this appliance is guaranteed only
if the appliance is correctly earthed in compliance with the
standards of electrical safety.
The manufacturer can under no circumstances be
considered responsible for any damage that might occur
due to incorrect earthing of the hob.
The electric hob is not supplied with a power supply cord
because the type of cord used depends on the type of
electrical connection (see following diagram). Open the
terminal box, following the instructions illustrated in the
diagram below:
Voltage and frequency of power supply:
230-240V
50-60Hz
6200W
Electrical Connections:
* Application of the simultaneity coefficient in compliance
with standard EN 335-2-6
Y-type connection in compliance with standard
EN 335-2-6
1 2
3
4
5
V
IMPORTANT POINTS:
Your hob is supplied with a special connection cable.
If ever the cable is damaged it should be replaced by an
authorised service engineer only.
Disconnect the hob form the electrical supply before any
work is carried out.
2
1
Connecting the supply cord to the electrical mains:
The hob must be connected to a double pole mains switch
which must be installed between the appliance and the
mains. The double pole mains switch must have a minimum
of 3mm of space between the contacts, be sized to the
load and comply with current regulations (the switch must
not be able to disconnect the earth conductor).
The supply cord should conform to BS6004 conductor size
4mm
2 and must be positioned so that no part of it reaches
a temperature of 50°C higher than room temperature.
Before making the connection, make sure that:
•
the limiter switch (fuse) and the residual wiring can
support the appliance load (see the rating plate).
• the mains system is properly earthed in compliance
with current regulations and provisions.
• there is easy access to the socket or the double pole
mains switch after the appliance is installed.
IMPORTANT:
If the hob is installed above a built-in oven, the electrical
connection for the hob must be independent of that for the
oven, both for safety reasons and to facilitate the removal
of the oven for maintenance, repair etc.
L N
Fuse 20 A*