Humminbird Wide 128 - Manual (Page 5)

INSTALLATION PREPARATION
TRANSDUCER EXCHANGE
TRANSDUCER EXCHANGE
Other transducers are available as replacements for the standard transducer. You may
exchange your new and unassembled transducer for another type by returning it to the
address listed in Customer Support. Some transducers may have additional cost. Refer
to the Accessory catalog or call Customer Support for information.
BEGINNING INSTALLATION
Now that you have determined the transducer mounting method you can begin
installation of your new Humminbird fishfinder. The installation guide included on the
next few pages provides detailed step by step instructions for installation of the control
head and transducer. For transom mount transducer installations you will need the
mounting template included with your manual.
In addition to the parts included you need the following for installation and operation:
•
A powered hand drill and various drill bits
•
Philips and flat-head screwdrivers
•
A ruler or measuring tape
•
Pen or pencil
•
12 volt power source (your boat’s battery)
•
A 1-amp fuse
•
A fuse holder (if you are wiring directly to the boat’s battery)
•
Silicone sealant (for sealing drilled holes)
•
2-part, slow-cure epoxy (for inside the hull transducer installations)