Huffy SKM 3072-U - Manual (Page 3)

P/N 205343A 7/97 3
Bottom View of Base
Lay base (1) bottom up and set wheel (2) into place.
With wheel and strut holder in place, insert spacer (6) thru notch in base, strut holder (3) and wheel (2). Then push
spacer thru hole in base. Install bolt (4) thru washer (5), spacer (6), second washer (5) and nut (7) then tighten.
Repeat STEPS 1 and 2 for the opposite side.
3
3.
1. 2.
4 5 6
5
7
2 1
Slide strut holder (3) between wheel (2) and
base (1).
NOTE: Wheel (1) has spacer snapped in place over axle
hole, the spacer should face the strut holder (3).
1
3 2
1
2