Honeywell TN924W - Manual (Page 19)

37
ACCESSING SUNRISE/SUNSET WINDOW
Press UP or DOWN until the sunrise and sunset icons
on the lower left of the
display will start flashing.
PROGRAMMING YOUR LOCATION
• In Sunrise/Sunset Window, press and hold SET until the city code in the
Time Window will flash entering the location programming mode.
• Select the city code closest to your area by pressing the UP or DOWN. Refer
to P. for a list of available codes. The corresponding longitude and latitude will
be displayed in Sunrise/Sunset Window along with the city code.
• If you wish to enter the geographical coordinates yourself, select the “USR”
(user) as a city code.
• Press SET to confirm your selection and enter into the geographical
coordinates programming mode – the latitude degrees will flash
PROGRAMMING LATITUDE, LONGITUDE, TIME ZONE AND DST
• Press UP or DOWN to adjust the digits. Press and hold either button for fast
advance.
• Press SET to confirm your selection.
• Repeat above procedure to set latitude and longitude minutes, longitude
degrees, time zone, and DST selection.
• Once programming is completed, the display will return to the Sunrise/Sunset
Window.
VIEWING LOCATION DATA
In Sunrise/Sunset Window press SET selecting either:
• Time and sunrise/sunset times
• Calendar and sunrise/sunset times
• Calendar and longitude/latitude
VIEWING SUNRISE/SUNSET TIMES FOR DIFFERENT DATES
• In Sunrise/Sunset Window, press MEMORY until the date in the Time
Window will flash
• Press UP or DOWN selecting the desired date. Press and hold either button for
fast digits advance
• The corresponding sunrise and sunset times will be displayed for the selected
date
• Press MEMORY or SET to return display to the Sunrise/Sunset Window
38
UNDERSTANDING OF SUNRISE/SUNSET INFORMATION
The sunrise time displayed in the morning will be different from the one displayed in the
afternoon/night:
For the period from 12 am to 12 pm the unit will display the sunrise time for a current day
For the period from 12 pm to 12am the unit will display a sunrise time for the next day
with the “NEXT DAY” icon
At some locations, especially with high latitudes, sunrise and sunset events may not
occur within 24 hours.
Display Sunrise status Display Sunset status
FULL Sunrise for the
previous day FULL Sunset on the
following day or
later
- - - - No sunrise for the
whole day - - - - No sunset for
the whole day
TEMPERATURE AND HUMIDITY WINDOW
The Weather Station supports up to 5 remote thermo hygrometers, corresponding to a
separate channel of the temperature and relative humidity display. The temperature can
be displayed in Celsius (ºC) or Fahrenheit (ºF).
The main unit carries the temperature and humidity sensor and uses this data to
calculate an indoors comfort level - Wet, Comfort or Dry.
A temperature alert function is available for each channel. It can be programmed to
sound if the channel temperature exceeds or falls below the pre-set upper and lower
limits. The limits are the same for all remote channels.
Thermo-Hygrometer remote battery status is monitored on the main unit.
Note: The temperature alarms have a 0.5 ºC deviation to prevent them from sounding due
to small temperature fluctuations that are close to the set alarm value. This means that
after the temperature reaches the alarm temperature, it will have to fall below the alarm
temperature plus the deviation (0.5°C) to activate the alarm.
COMFORT LEVEL INDICATION
The main unit is capable of detecting and displaying the current indoor comfort levels of
surrounding environment. The comfort level based on the combination of the current
indoor temperature and humidity readings. The following comfort levels may be displayed:
COMFORT (comfortable); WET (wet) and DRY (dry).