Harbor Freight Tools 40315 - Manual (Page 14)

SKU 40315 For technical questions, please call 1-800-444-3353. Page 14
2. Loosen the Star Knob (20), and adjust the Cutting Guide (57) to the desired
cutting
width . Then, retighten the Star Knob. (See Figure G.)
3. If necessary, loosen the second Star Knob (20) and tilt the Table (51) to adjust
the
angle of the cut. Then, retighten the Star Knob. (See Figure G.)
4. Connect the Power Cord/Plug (34) of the Tile Saw to the nearest 120 volt, grounded,
electrical outlet.
5. Put on your ANSI-approved safety impact eye glasses underneath an ANSI-
approved safety impact full face shield.
6. Turn the Power Switch (21) to its “ON” position, and allow the Cutting Wheel
Blade (8) to spin up to full speed. (See Figure G.)
7. Check to make sure the Cutting Wheel Blade (8) is picking up water from the Tray
(17). If not, turn off the Tile Saw. Unplug the machine, and refill the Tray to the
appropriate level. Then, restart the Tile Saw. (See Figure G.)
8. Place the workpiece you are cutting firmly against the Cutting Guide (57), and slowly
feed the workpiece into the revolving Cutting Wheel Blade (8).
(See Figure G.)
9. CAUTION! Make sure to keep hands and fingers away from the Cutting
Wheel Blade (8). Also, make sure to hold the workpiece you are cutting firmly
against the Cutting Guide (57) throughout the cutting process. Failure to do so
may cause the workpiece to be propelled by the Cutting Wheel Blade toward
your body and/or into the Tile Saw. (See Figure G.)
10. Once the cut is complete, turn the Power Switch (21) to its “OFF” position.
Unplug the Power Cord/Plug (34) from its electrical outlet. Allow the Cutting
Wheel Blade (8) to stop on its own. Then, remove the workpiece and any scrap
material from the Table (51) of the Tile Saw. (See Figure G.)
11. Remove and empty the Tray (17) of its contents, and thoroughly rinse
the Tray with clean, cold water. Then, replace the Tray.
(See Figure G.)
12. Make sure to store the Tile Saw in a safe, clean, dry location out of reach of
children and other unauthorized people.
ON OFF