Hotpoint BWM 129 - Manual (Page 11)

9
GB
DOOR LOCKED led:
If this LED is on, the appliance door is locked to prevent it from being opened accidentally; to avoid any
damages, wait for the LED to flash before you open the appliance door.
The rapid flashing of the DOOR LOCKED Led together with the flashing of at least one other LED
indicates there is an abnormality. Call for Technical Assistance (see page 15).
Cycle phase under way:
During the wash cycle, the LEDs gradually illumi-
nate on to indicate the cycle phase under way:
Prewash
Wash
Rinse
Spin
Note: during draining, the LED corresponding to
the Spin cycle phase will be turned on.
Function buttons
The FUNCTION BUTTONS also act like LEDS.
When a function is selected, the corresponding
button is illuminated.
If the function selected is incompatible with the
programme set, the button will flash and the
function will not be enabled.
If you set a function that is incompatible with
another function you selected previously, only the
last one selected will be enabled.
Leds
The LEDS provide important information.
This is what they can tell you:
Delay set:
If the Delay Start function has been enabled (see
page. 11), once you have started the programme,
the LED corresponding to the delay set will begin
to flash:
As time passes, the remaining delay will be
displayed, and the corresponding LED will flash:
Once the set delay is complete, the flashing LED
will turn off and the programme set will start.
Prewash
Wash
Rinse
Spin
2hr
4hr
6hr
9hr
Prewash
Wash
Rinse
Spin
2hr
4hr
6hr
9hr
Service
Troubleshooting
Precautions
Care
Programmes
Detergents
Installation
Description