Healthrider HREX1395.0 - Manual (Page 6)

6
6. The Console (76) requires four “C” batteries (not
included); alkaline batteries are recommended. Insert
four batteries into the back of the Console. Make sure
that the batteries are oriented as shown by the
markings inside of the Console.
While another person holds the Console (76) near the
Console Bracket (6), feed the console wires through
the large hole in the Console Bracket. Next, connect
the console wires to the Upper Wire Harness (77) and
the Upper Pulse Wire (75). Then, insert all wires into
the top of the Upright (5).
Attach the Console (76) to the Console Bracket (6)
with four M4 x 12mm Screws (106).
6
76
6
5
106
5
5
5. While another person holds the Upright (5) near the
Frame (1), connect the Upper Wire Harness (77) to
the Lower Wire Harness (66). Next, connect the Upper
Pulse Wire (75) to the Center Pulse Wire (88). Insert
the excess wire into the Frame.
Slide the Upright (5) onto the Frame (1). Attach the
Upright with three M8 x 16mm Screws (62) and three
M8 Curved Washers (107). Be careful to avoid
pinching the wires.
4
10
87
4
10
3
87
4. Set the Seat Bracket (3) in the Seat Frame (4), and
align the holes. Attach the Seat Bracket with four M8 x
16mm Bolts (87) and four M8 x 20mm Washers (10).
Be careful to avoid pinching the Pulse Wire (71).
Connect the Pulse Wire (71) to the Lower Pulse Wire
(92).
10
71
107
62
107
62
62
66
77
75
77
75
1
92
88
106