haier IPD-100 - Manual (Page 3)

Read these instructions. Keep these instructions. Follow all instructions. Heed all
warnings.
Install this unit in accordance with the manufacturer’s instructions.
Only use attachments / accessories specified by the manufacturer.
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the unit. When a cart is used, use caution when moving the cart/unit
combination to avoid injury from tip-over.
Use replacement parts as specified by the manufacturer.
Do not install this unit near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that produce heat.
The unit shall not be exposed to dripping or splashing water and no object filled with
liquids, such as vases, shall be placed on the apparatus.
Do not use this apparatus near water and clean the unit with dry cloth only.
Disconnect the unit from the power source when cleaning.
No naked flame sources, such as lighted candles, should be placed on the unit.
Keep the player clean and never store it next to a heat source or in dirty, humid or wet
places. Keep it out of direct sunlight.
Do not block any ventilation openings; the ventilation should not be impeded by covering
the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.
Give minimum 100 mm distances around the apparatus for sufficient ventilation.
To prevent fire or shock hazard, do not expose this unit to rain or moisture.
Do not subject the product to harsh impacts. Do not drop the appliance. This may result
in damage to the product and loss of data.
Care required with the use of this apparatus in extreme climates.
Do not use this apparatus in an extremely dry environment, as this can lead to static
discharge which can damage the player.
This unit may be subject to inoperability to a strong electromagnetic field or other
interference. If this occurs, turn the unit’s power off, then disconnect the power plug from
the “DC IN” on back of unit. After a few minutes, reconnect the power jack into “DC IN”
input to reset the unit software, and the unit should return to normal operation.
To prevent fire or shock hazard, do not use this plug with an extension cord, receptacle
or other outlet unless the blades can be fully inserted to prevent blade exposure.
Unplug this unit during lightning storms or when unused for long periods of time.
Where the MAINS plug is used as the disconnect device, the disconnect device shall
remain readily operable.
1.)
2.)
3.)
4.)
5.)
6.)
7.)
8.)
9.)
10.)
11.)
12.)
13.)
14.)
15.)
16.)
17.)
18.)
19.)
20.)
IMPORTANT SAFETY INSTRUCTIONS
2